program keypad chamberlain garage door opener

#Program keypad chamberlain garage door opener how to#

See STEP 3 SINGLE DOOR OPERATION for further instruction This completes the programming of a single door.Press the UP/DOWN key 3 to 4 times slowly until the garage door opener operates. Place garage door opener into PROGRAMMING MODE as illustrated below.Ģ. STEP 2A) PROGRAMMING THE KEYPAD TO 1 OPENER- (if you have more than one garage door skip to the next step.)ġ. If LED did not blink twice and shut off, please see RESETTING THE KEYPAD (FACTORY DEFAULT) section.See STEP 2B PROGRAMMING FOR MULTIPLE OPENERS if using the keypad to operate up to 3 doors.The keypad is now programmed with a PIN number and ready to program to the garage door opener(s).Program the keypad for the first time* with a Personal Identification Number (PIN).

#Program keypad chamberlain garage door opener how to#

How to program the Wireless Keypad, Genie garage door openersįor use with Genie Intellicode® garage door openers

Wait 15 seconds until the backlighting shuts off before entering a valid PIN or resetting the keypad to reprogram.

The Keypad LED, PROGRAM key and Number pad black light will flash rapidly indicating a problem with the programming or invalid PIN entry. The Keypad LED and PROGRAM key will flash slowly and the number pad backlight will remain on for 15 seconds indicating a successful program or valid pin number has been entered.

The keypad LED will flash each time a key is pressed and entry is accepted. Reinstall the battery compartment door to begin programming. *It is recommended to complete the programming before mounting the keypad.Īctivate the Genie wireless keypad (GK-R) by opening the battery cover compartment and pull the protective tab. GK-R (Genie Garage Door Opener Keypad) Programming Quick Reference Card